我的订单|我的收藏|我的商城|帮助中心|返回首页
合肥芜湖滁州蚌埠晟晖>新闻>高压清洗机新闻

伊宁洗地机

文章来源: 作者: 发布时间:2020年05月30日 点击数: 字号:

伊宁洗地机常见事故及其处理方法

Common accidents of washing machine and their treatment

[指南资料]研究表明,自动扫地机的大部分故障是人为因素造成的,而工作环境的影响也占很大比例。如果您使用的全自动洗地机在最合适的环境中使用,则可以在正常时间使用。在这种情况下,您遇到的问题很容易解决。不要在异常的工作环境中使用该机器。接下来,让编辑向您介绍它!

[guide materials] research shows that most of the failures of automatic sweepers are caused by human factors, and the impact of working environment also accounts for a large proportion. If the fully automatic floor washer you use is used in the most suitable environment, it can be used in normal time. In this case, the problems you encounter are easy to solve. Do not use the machine in an abnormal working environment. Next, let the editor introduce it to you!

问题1:伊宁洗地机的清洗不完整

Problem 1: cleaning of automatic floor washer is incomplete

伊宁洗地机检查刷盘的磨损情况,必要时用同一规格的刷盘更换;在真正污秽的地面上清洗时,应使用特殊的刷盘,必要时应特别提供。

Check the abrasion of the brush disc and replace it with a brush disc of the same specification if necessary; when cleaning on the really dirty ground, use a special brush disc and provide it if necessary.

问题2:伊宁洗地机自动洗地机的吸水率不好。

Problem 2: the water absorption of the automatic washing machine is not good.

1.伊宁洗地机检查吸力马达开关是否开着

1. Check whether the suction motor switch is on

二.伊宁洗地机检查吸入管是否已正确插入污水槽入口;

2、 Check whether the suction pipe has been correctly inserted into the sewage tank inlet;

3.伊宁洗地机检查胶条是否干净,是否还留有固体残留物

3. Check whether the rubber strip is clean and whether there is solid residue left

4.伊宁洗地机更换断带,调整吸力带的角度。为了正确使用,吸力带的高度应根据胶带的磨损情况调整。在清洗过程中,后带应向后向后弯曲。

4. Replace the broken belt and adjust the angle of suction belt. In order to use it correctly, the height of suction belt should be adjusted according to the abrasion of the belt. During cleaning, the rear belt should be bent back.

5.伊宁洗地机拆卸抽吸装置,并请将其清洗

5. Remove the suction device and clean it

6.检查滑轮的调整情况

6. Check the adjustment of pulley

问题三:伊宁洗地机泡沫太多

Question three: too many bubbles

检查是否使用地面泡沫清洁剂,如有必要,在污水槽中加入一些低泡沫剂,如果地面上有大量污垢,会产生大量泡沫,此时应稀释清洁剂。

Check whether to use floor foam cleaners. If necessary, add some low foaming agents in the sewage tank. If there is a lot of dirt on the floor, there will be a lot of bubbles. Dilute cleaners should be diluted at this time.

问题4:伊宁洗地机的刷盘上没有足够的水。

Problem 4: there is not enough water on the brush plate of the automatic floor washer.

检查将水输送到刷盘的管道是否堵塞

Check whether the pipeline for water delivery to the brush disc is blocked

二.伊宁洗地机检查水阀是否开着。

2、 Check that the water valve is open.

3.检查水箱中的水量

3. Check the water volume in the water tank

4.检查水过滤器是否干净

4. Check whether the water filter is clean

洗地机疑难病"的解决方案

The solution to the difficult problems of washing machine

如果自动洗地机长期使用后保养不好,就会导致故障。为了避免在使用过程中影响正常工作,用户必须能够不适当地适应,及时发现问题,并解决故障。

If the automatic washing machine is not well maintained after long-term use, it will lead to failure. In order to avoid affecting normal operation in the process of use, users must be able to adapt improperly, find problems in time, and solve faults.

条件1:洗地机的污水吸收效果差。

Condition 1: the waste water absorption effect of the washing machine is poor.

1.首先,检查电池是否足够。

1. First, check whether the battery is sufficient.

2.污水槽顶部的胶带是否有磨损,如有必要,更换新的吸水性胶带

2. Check whether the tape on the top of the sewage tank is worn. If necessary, replace it with a new absorbent tape

3.如果胶带没有磨损,检查带材的位置是否相互偏离,并调整带材与地面之间的高度。通常,后胶带在清洗时应向后弯曲。

3. If the tape is not worn, check whether the position of the strip deviates from each other and adjust the height between the strip and the ground. In general, the rear tape should be bent back when cleaning.

4.污水槽盖不严格封闭,污水管盖不盖好,可能导致洗地机吸力不足。

4. The cover of the sewage tank is not strictly closed, and the cover of the sewage pipe is not well covered, which may lead to insufficient suction of the washing machine.

5.如吸入管损坏,更换吸入管,如未损坏,则检查吸入管与污水舱之间的连接是否正确。

5. If the suction pipe is damaged, replace the suction pipe. If not, check whether the connection between the suction pipe and the sewage tank is correct.

6.污水吸入管内有垃圾,导致堵塞,并可使洗地机不能吸收水,因此应清除堵塞。

6. There is garbage in the suction pipe of sewage, which causes blockage and prevents the scrubber from absorbing water. Therefore, the blockage shall be removed.

7.吸水机损坏或内线短路,这种情况更麻烦,最好联系厂家申请售后。

7. The water absorption machine is damaged or the internal wire is short circuited, which is more troublesome. It is better to contact the manufacturer to apply for after-sales service.

条件二:洗地机不动

Condition 2: the floor washer does not work

电池可能没电了

The battery may be dead

2.检查刷盘在地面上的压力是否过大。如果是,适当调整刷盘高度,降低压力。

2. Check whether the pressure of brush disc on the ground is too large. If yes, adjust the brush disc height properly to reduce the pressure.

3.检查万向盘是否能灵活转动。如果很难转动,万向盘可能会被什么东西缠住。

3. Check whether the universal disk can rotate flexibly. If it's hard to turn, the gimbal may get caught in something.

4.连接万向盘的轴承生锈,可以添加润滑油。

4. The bearing connecting universal disk is rusty, and lubricating oil can be added.

地区导航: 六安| 合肥| 蚌埠| 巢湖| 池州| 滁州| 阜阳| 淮北| 淮南| 黄山| 马鞍山| 铜陵| 芜湖| 宿州| 宣城
北京| 天津| 上海| 重庆| 乌鲁木齐| 拉萨| 银川| 呼和浩特| 南宁| 哈尔滨| 长春| 沈阳| 石家庄| 济南| 南京| 杭州| 福州| 广州| 海口| 昆明| 贵阳| 成都| 长沙| 武汉| 郑州| 太原| 兰州| 西宁| 南昌